JetsonHacks

Developing on NVIDIA® Jetson™ for AI on the Edge

Category: Hardware

The Heat Sink Chronicles: Redemption?

September 10, 2014
No Comments

A few days ago I installed a Enzotech CNB-R1 Heat Sink onto a Jetson TK1. As noted in earlier posts, with the heat sink installed the Jetson tends to run […]

Jetson TK1 Heat Sink Temperature results

September 9, 2014
2 Comments

After installing the Enzotech CNB-R1 Northbridge heat sink, I ran a temperature test using the CUDA Smoke Demo. Basically start up the demo, and take temperature readings over the next […]

Replacing the fan with a heat sink

September 5, 2014
One Comment

The NVIDIA Jetson TK1 is a nice development board. With that said, the little CPU fan cooler squeals like a stuck pig. It’s not horrible when you’re in a noisy […]

Jetson TK1 SSD Installation

August 28, 2014
10 Comments

Being a new development board, I’ve been a little leery to add peripherals that require driver support. In part, this was due to my first experiences trying to get wireless […]

NVIDIA Jetson TK1 with Arduino Uno

August 28, 2014
6 Comments

Connecting a Jetson TK1 to an Arduino UNO is a fun way to get started exploring electronics. Looky here: Installation Plugging an Arduino into the Jetson TK1 through a USB […]

NVIDIA Jetson TK1 Unboxing

June 29, 2014
2 Comments

In the NVIDIA Jetson TK1 Unboxing video we open the box in an action packed adventure. Looky here: Introduction The NVIDIA Jetson TK1 Development Kit is built around the Tegra […]

Disclaimer

Some links here are affiliate links. If you purchase through these links I will receive a small commission at no additional cost to you. As an Amazon Associate, I earn from qualifying purchases.

Books, Ideas & Other Curiosities