Developing on NVIDIA® Jetson™ for AI on the Edge

Day: September 3, 2015

GPS through Jetson GPIO UART
Testing With the wiring completed, we can try out our new GPS system. Turn on the power and boot the Jetson. Once the Jetson is up and running, open a […]
Wiring the Breadboard First solder the header pins to the level shifter and GPS breakout boards. The easiest way to do this is to place the header pins in the […]
Building a breadboard to interface a GPS system to a UART on the Jetson TK1 only requires a couple of parts, a GPS breakout board and a Level Shifter breakout […]


Some links here are affiliate links. If you purchase through these links I will receive a small commission at no additional cost to you. As an Amazon Associate, I earn from qualifying purchases.

Books, Ideas & Other Curiosities